Services


Services
Ways of Replacing your Garbage Disposal
It can be daunting when you are thinking of replacing you garbage disposer. When it comes to water and electricity people always have trepidation. The sink may leak since the sink connections are unfamiliar. You should learn how garbage disposal are since it is very easy to replace you garbage disposal. Read more about  Garbage Disposal  at  replaceyourgarbagedisposal.com. Old units should be checked to ensure that they are not jammed hence you should not buy the old units before you check how the units are. Jammed disposals are very common hence you should check your connection if the disposal unit is working well. You need to consider the following factors when replacing your garbage disposal.

Your electricity should be turned off. Your electricity should be turned off to ensure that your disposal unit is not connected with an electric current. When you want to work on your disposal unit, turning off your electricity is very important. It is important that you remove the cover of the disposal unit. At the base of the disposal unit is where you will find the cover. You should loosen the screw and remove the wires connecting to the disposal unit.

The bolt that covers the disposal is the one that you should remove. The hose should be pulled from the fitting by loosening the hose clamp. Once the bolt is lose, you should remove the old unit. You should support the disposal unit from below for you to remove the disposal unit. The disposer should be rotated counterclockwise as the next step. This will be until the unit does fall away. The remainder should be removed by you until all the three bolts fall off.

You should apply the putty. Putty is applied in times that you want to install the new drain. The putty should be rolled on the counter that is  1/2  thick. You should firmly press towards the sink hole when you stick the putty at the underside. To get more info, click www.replaceyourgarbagedisposal.com. You should then finish the drain assembly by sliding the cardboard washer while backing it up with the ring. There should be mounting of the snapping ring. By retaining the snap into the drain, the drain should be drained. There should be draining of the drain by retaining the snap into the drain.

There should be tightening of the bolts. There should be tightening of the bolts by using the screwdriver. You should snug the drain with the sink. When you are looking to install a new drain this is important. You should perform wiring of the new disposer to make it flexible. When it comes to upgrading the disposal, this will help. You should then finish up by bring the wires into the conductor. Securing of the conductor is what you will manage to get by this process. Learn more from https://en.wikipedia.org/wiki/Garbage_disposal_unit.

This site was built using